Front door
1. Disconnect the wire from the negative terminal of the battery (see chapter 5).
2. Using a plastic wedge, wring out and remove the main switch panel (see resist. illustration) power window controls from the upholstery of the driver's door.
27.2 Removing the driver's door main switch panel with a plastic wedge (1)
3. To remove the passenger door switch panel, you must remove the front door trim (see chapter 11).
4. Disconnect the wiring connector from the back of the switch panel (see resist. illustration).
27.4 Disconnecting the wiring connector of the power window control switch panel (front doors)
5. To remove the switch panel of the passenger door, it is also necessary to press the latches on the back of the upholstery.
6. Installation is carried out in the reverse order.
Backdoor
Note: The power windows of the rear doors are installed with a certain configuration of the model.
7. Disconnect the wire from the negative terminal of the battery (see chapter 5).
8. On GTS Sedan/Hatchback models, remove the rear side door upholstery. Release the clips on the back of the upholstery and remove the power window switch together with the tweeter trim.
9. On Wagon/Signum models, use the plastic wedge to carefully pry the switch panel together with the tweeter trim in the door armrest (see resist. illustration) and push it out.
27.9 Removing the individual rear power window switch (Wagon/Signum models)
10. Remove the switch from the panel and disconnect the switch wiring connector.
11. Installation is carried out in the reverse order.
Visitor comments