Specifications System type Sealed, with separate expansion tank Thermostat: Petrol engines: – opening start temperature 92°C – full opening temperature 107°C Diesel engine...
Coolant hoses — replacement Check up a condition of hoses of system of cooling and at detection of defect replace a hose. Replacement 1. Drain the coolant from the cooling system. 2....
Radiator — removal, inspection and installation Removing Models without air conditioning 1. Remove the ground wire from the battery. 2. Raise the front of the car and secure it on stands. 3. Drain the...
Thermostat — removal, check and installation 1.6L soch engines Warning! When installing the thermostat, a new O-ring must be installed. Removing 1. Remove the ground wire from the battery. 2. Drain the...
Radiator fan — check, removal and installation Examination The electrical power to the cooling fan is supplied through the ignition switch and fuse. The fan is controlled by a temperature sensor installed...
Additional radiator fan on 1.7L diesel engines Removing 1. Remove the front bumper. 2. Remove the right headlight. 3. Remove the screws from the fan shroud. 4. Disconnect the electrical wires from the...
Water pump — removal and installation 1.6L petrol engines Removing 1. Remove the ground wire from the battery. 2. Drain the coolant from the cooling system. 3. Remove a gear belt and a back casing...
Coolant temperature sensor Removing 1. Drain the coolant from the cooling system. 1.6L SOCH petrol engine 2. Unscrew the bolt and remove the torque compensator rod from the right side of...
Coolant level sensor — removal and installation The sensor is located in the expansion tank. Removing 1. Unscrew the cap of the filler neck of the expansion tank and remove the residual pressure in the...