A few words about this guide This manual covers Sedan, Hatchback, Wagon models with in-line 4-cylinder gasoline engines DOHC: 1.6, 1.8, 2.2 l, diesel DOHC 1.9 l, SOHC: 1.9, 2.0 and 2.2 l,...
Rules for using this manual The guide is divided into chapters. Each chapter is divided into numbered sections. Sections, in turn, are divided into subsections and, where required, into...
Annotation for cars Opel Vectra C and Signum Opel Vectra-C has been produced since March 2002 in three body styles: Sedan, GTS 5-door Hatchback and Wagon. This is a completely new car - its design does...
List of abbreviations used in the manual Russians AT Automatic transmission VV High voltage TDC Top Dead Center Timing Gas distribution mechanism GHZ Brake Master Cylinder road traffic accident DU...
Identification numbers, VIN number, decoding Product improvement is a continuous process of any in-line production. At the same time, in the automotive industry, with the exception of cases of major...
Overall dimensions and weight characteristics Dimensions body type Sedan Hatchback GTS station wagon Slgnum Full length, mm 4611 4611 4839 4651 Width with folded exterior mirrors, mm 1798 1798 1798 1798...
Vehicle Specifications Technical data determined according to EU regulations. Changes are possible. The data given in the technical passport of the car always take precedence over...
Oils, lubricants, sealants There are many chemicals, oils and lubricants on the market that are needed during the routine maintenance and repair of a car. This includes a wide range of...
Recommended lubricants and fluids Note: Lubricants and fluids recommended for use by the vehicle manufacturer at the time of writing this manual are listed below. If the Manual does not contain...
Vehicle settings and adjustments Entitled «settings» this Manual does not imply a single procedure for adjusting any of the parameters of the car's systems, but a whole range of adjustments to...
Running in the first 1000 kilometers Careful attitude to the power unit at the initial stage of vehicle operation is the key to its reliable and efficient functioning during the entire remaining...
Starting the engine and driving Preparing for a car trip Before starting the engine and driving the car, always make its external visual inspection, make sure that nothing prevents the car...
Driving vehicles with a manual transmission The vehicles covered in this manual are fitted with a 5-speed manual transmission. The gear lever is floor-mounted and is placed on the center console. The...
Driving vehicles with automatic transmission General information Attention! An automatic transmission is a very technically complex system - independent attempts to interfere in its operation and...
Driving vehicles with CVTronic automatic transmission When equipped with a 6-speed AT vehicle with a CVTronic system, gearshift control can be carried out in three modes: Auto Soft Switch Mode (position «D» J;...
Special Driving Modes On AT-equipped models, additional electronically controlled driving modes are available if equipped. Attention! Electronic equipment is very sensitive to...
Vehicle braking General information The principle of operation and design of the components of the brake system are discussed in detail in Chapter 9 of this manual. All...
Operation of vehicles with a catalytic converter Attention! Exhaust system components can reach very high temperatures - avoid touching hot components and avoid parking on areas covered with flammable objects...
Transporting children and installing a child seat Ensuring the safety of transporting children Warning! The statistics of deaths and injuries in road accidents show that it is safest to install child seats in...
Economic driving tips Fuel consumption is largely determined by driving style and vehicle operating conditions. In order to reduce fuel consumption, try to adhere to the following...
Towing a trailer and installing a tow bar General information Note: When towing a trailer, the service life of the vehicle and its efficiency are reduced, because. increases the load on the components...