Description of the clutch design The transmission case is made by casting from aluminum alloy, and is bolted to the left (in the direction of the car) side of the engine. The transmission...
Clutch Specifications Type - Single disc, dry, with diaphragm spring and hydraulic drive Follower Diameter (frictional) disk, mm: Z16XE — 200 Z18XE — 205 Z20NET/Z32SE/Z19DT (H)...
Removal and installation of the clutch master cylinder 1. The clutch master cylinder is attached to the rear bulkhead of the engine compartment. 2. Remove the battery from the tray ( see chapter 5 ). 3. Use a clamp...
Removal and installation of the clutch pedal 1. The clutch pedal is fixed in a support bracket installed in the front wall of the passenger compartment under the instrument panel. It comes off with the...
Removing, checking and installing clutch components Attention: Remember that the dust generated during the wear of the friction linings of the clutch disc may contain asbestos, which is harmful to health. Do not...