Car body exterior Opel Vectra A

General information
Opel Vectra/Calibra cars have a monocoque body. The bottom, side parts, roof and rear wings are welded. Therefore, significant damage to the body can only be...

Removal and installation the front bumper
Vectra cars Removal Remove the radiator grille. To do this, press the retaining strips with a screwdriver and remove the grille. Disconnect the connectors from...

Removal and installation the rear bumper
Vectra cars Removal Remove the license plate light. Remove the inner lining of the rear wall. Unscrew the two nuts on the back wall. Pull the bumper back out...

Removal and installation the hood
Vectra/Calibra cars An assistant will be required to carry out the work. Removal Open and prop up the hood. Disconnect the supply pipes from the windshield...

Removal and installation front fenders
Vectra/Calibra cars Removal Remove the front bumper. Remove the direction indicator. Raise the hood. Protect the hood and hinges from damage with adhesive...

Additional installation of trunk lid trim
Vectra cars Some Vectra models are equipped with a boot lid trim. This trim can be installed independently. Installation Remove the trunk handle. Trunk lid The...

Removal and installation moldings
Vectra cars Removal The glued moldings can be removed from the body after heating with a hair dryer. To do this, heat the molding in parts and peel it off. Be...

Removal and installation the trunk lid/fifth door lock
Vectra cars Removal Remove the inner trim of the fifth door. Trunk lid The fifth door Loosen the screws securing the trunk lid lock. Unhook the rods and remove...

Removal and installation the trunk lid/fifth door lock cylinder
Vectra cars Removal Remove the inner trim of the fifth door. Insert the key into the lock to prevent the discs from falling out when removing the cylinder....

Removal and installation mirror glass
Vectra cars Removal Using a wide spatula, lift the mirror glass and push it away from the ball joint. To avoid damaging the glass, place a rag or piece of...

Removal and installation the outside mirror
Vectra cars Removal For a manually adjusted mirror: remove the adjustment knob. Remove the triangular cover from the door. For the electric mirror: release and...

Removal and installation the mirror drive motor
Vectra cars Removal Remove the mirror glass. Disconnect the electric heating connector. Loosen the screws securing the mirror drive motor. Loosen and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: