Car gearbox Opel Vectra A

Removal and installation the gearbox
Removal Disconnect the ground wire from the battery. Loosen the gearshift rod mounting clamp (see arrow in fig.). Engage 2nd or 4th gear and disconnect the...

Visual detection of oil leaks
Oil leaks are most likely to occur in the following places: at the junction of the cylinder block and gearbox; on the oil drain and filler plugs; on the seal...

Checking the gearbox oil level
The gearbox oil is not replaced. Its level should be checked every 30,000 km in accordance with the maintenance manual. At the same time, it is also necessary...

Drive adjustment
The gearbox control drive must be adjusted if individual gears do not engage, the clutch does not engage, or after replacing the drive itself. When the drive...

Automatic transmission. General information
Opel Vectra/Calibra vehicles can be optionally equipped with a 4-speed automatic transmission. The gearbox is controlled by an electronic unit (computer)...

Checking the oil level and changing the oil in the automatic transmission
The correct oil level is essential for the perfect operation of the automatic transmission. It must be checked annually, but not less than every 15,000 km....

Automatic transmission oil change
ATF oil should be replaced every 45,000 km. Without oil, the engine cannot be started or the vehicle can be towed. Attention! The oil must be changed when the...

Adjusting the automatic transmission gear selector lever rod
Shift gear selector lever alternately to position "P", "R", "N", "D", "3", "2", "1". Pull the button on the lever until it stops; the lever should lock into...

Automatic transmission fault codes
Flashing lamp (gear symbol) on the instrument panel signals a malfunction of the automatic transmission. To display the fault codes, connect contacts C and A...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: