General information about the gasoline fuel system The fuel system consists of a fuel tank mounted under the rear of the vehicle, an electric fuel pump submerged in the tank, a fuel filter, a fuel line and fuel...
Specifications System type SOHC 1.6 liter engines Multec (single point fuel injection system) DOHC 1.6 liter engines Multec-S (multipoint fuel injection system) Engines 1.8...
Air filter and intake ducts — removal and installation Removing the intake duct on models with 1.8 and 2.0 liter engines On these models, the inlets are bolted on. Removing 1. To remove the air filter cover, loosen...
Engine air temperature control system System (single point injection) controlled by a temperature sensitive vacuum switch installed in the throttle housing. When the throttle air temperature is...
Accelerator pedal — removal and installation Removing 1. In the car, unscrew the clips and remove the bottom panel from the driver's side. 2. Remove the accelerator cable from the top of the throttle...
Fuel — general information Gasoline engines use fuel with a minimum octane rating of 95. Fuel with an octane rating of 91 can be used because the engine management system automatically...
Single point fuel injection system SOCH 1.6L engine Central injection system Multec SOCH engine 1.6 l 1. Crankshaft position sensor 2. Throttle body 3. Fuel injectors 4. Throttle potentiometer 5. Knock sensor 6....
Relieve pressure in the fuel system Warning! When working on the fuel system, you must first remove the pressure in the system. 1.6L SOCH engines 1. Switch off the ignition. 2. Remove the cover...
Fuel pump — removal and installation Removing 1. Relieve pressure in the fuel system and remove the ground wire from the battery. 2. Move the rear seat cushion forward and lift the carpet over the...
Fuel level sensor — removal and installation Removing 1. Relieve pressure in the fuel system and remove the ground wire from the battery. 2. Move the rear seat cushion forward and lift the carpet over the...
Fuel tank — removal and installation Warning! When working on the fuel tank, do not use open flames or tools that may generate sparks. When removing the fuel tank, the level of fuel in it should...
Throttle body — removal and installation Removal and installation 1.6L soch engines 1. Relieve pressure in the fuel system and disconnect the negative terminal from the battery. 2. Loosen the clamp...
Checking the fuel injection system If there is a malfunction in the fuel system, first check that all electrical connectors are securely connected and protected from corrosion. Also check the...
Elements of a single point fuel injection system Fuel burner The fuel injector, centrally mounted in the throttle body, is a solenoid valve that supplies a certain dose of fuel for the corresponding engine...
Inlet manifold — removal and installation Removal and installation 1.6L SOCH engines 1. Relieve pressure in the fuel system and remove the ground wire from the battery. 2. Remove the auxiliary drive...
Exhaust manifold — removal and installation Removal and installation 1.6L SOCH engines 1. Disconnect the electrical connector from the oxygen sensor located on the sensor wires. Release the sensor wiring...
Exhaust gas exhaust system The exhaust system consists of a front exhaust pipe, an additional silencer and a main silencer. In cars with an exhaust gas treatment system, a catalyst is...