The interior and interior of the car Opel Vectra C

Caring for upholstery, trim and carpeting
1. Remove the carpets and mats every 3 months and clean the interior trim panels. This procedure can be done more often if necessary. To remove debris, as well...

Removal and installation of sun visors, ceiling handle
1. Release the edge of the sun visor from the bracket (see accompanying illustration), unscrew the 2 screws securing the swivel bracket and remove the visor....

Removal and installation interior rear view mirror
1. On models not equipped with a rain sensor, to remove the interior rearview mirror, you need to press the locking clip with a screwdriver (see accompanying...

Removal and installation the main storage compartment
1. Remove the instrument panel trim strip ( see Section 37 ). 2. Remove the main glove compartment light ( see Chapter 12 ). 3. Remove the 2 lower glove box...

Removal and installation the central console of the passenger compartment
Front section 1. Disconnect the cable from the negative terminal of the battery ( see Chapter 5 ). 2. Remove the rear section of the center console (see...

Removal and installation ashtrays
Front ashtray 1. Using a plastic wedge, remove the gearshift lever/selector housing trim frame from the center console ( see illustration 34.4 ). 2. Open the...

Removal and installation the automatic transmission selector lever base cover
1. Remove the tray and the front ashtray mounting housing ( see Section 35 ). 2. Using a plastic wedge, remove the decorative frame of the selector lever niche...

Removal and installation the decorative strip of the instrument panel
1. Pry up the left/right section of the decorative strip with a plastic wedge (see accompanying illustration), and moving the wedge along the edge of the...

Removal and installation the side decorative panel of the console section of the instrument panel
1. Using a plastic wedge, pry off the decorative cap of the corresponding front mounting screw of the front section of the center console (see accompanying...

Removal and installation the lower decorative cover of the instrument panel under the steering column
1. Set the steering column to its highest position and remove the exterior lighting/instrument lighting switch module (panel) ( see Chapter 12 ). 2. Remove 5...

Removal and installation steering column covers
1. Remove the instrument panel trim strip ( see Section 37 ). 2. Remove the lower decorative cover of the instrument panel under the steering column ( see...

Removal and installation the door seal
1. Open the door and remove the seal from the door frame (see accompanying illustration). 41.1 Door seal (1): 2. Seal joints; 3. Inner edge 2. When installing...

Removal and installation the interior sill trim panel
1. Open the front and rear doors on the corresponding side and remove the door opening seal ( see Section 41 ). 2. On SIGNUM models, remove the luggage...

Removal and installation the front body pillar trim (A-pillar)
Top finish Caution: When equipping your vehicle with head airbags, strictly follow safety precautions! 1. Disconnect the wires and insulate the battery...

Removal and installation the trim of the central body pillar (B pillars)
Top finish 1. Disconnect the wires and insulate the battery terminals. Wait at least 1 minute to allow the SRS independent power supply capacitor to discharge...

Removal and installation rear body pillar trim (C and D pillars)
All models Caution: When equipping your vehicle with head airbags, strictly follow safety precautions! 1. Before performing work, disconnect the wires and...

Removal and installation luggage compartment side trim
Sedan/Hatchback (GTS) 1. Open the trunk lid/tailgate. 2. On Hatchback (GTS) models, remove the luggage compartment parcel shelf and fold the rear bench seat...

Removal and installation the rear luggage compartment shelf for hand luggage (Sedan models)
1. These models have a shelf for small carry-on luggage between the rear window and the rear bench seat. 2. To remove the shelf, you must first remove the...

Removal and installation the lower edge trim of the trunk
Models Sedan/Hatchback (GTS) 1. Open the trunk lid/tailgate, fold back the handle of the removable upper floor cover and remove the cover. 2. Fold up the 2...

Removal and installation the front seat
Caution: When equipping your vehicle with side airbags, strictly follow the safety precautions! 1. Disconnect the wires and insulate the battery terminals....

Removal and installation the rear bench seat
Removal and installation the rear bench seat cushion Models Sedan/Hatchback 1. Lift the rear bench seat cushion and release it from its mountings on the...

Removal and installation the instrument panel
Note: The removal/installation procedure is quite labor-intensive, it is recommended to entrust these operations to service station specialists. 1. To remove...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: