Car body exterior Opel Vectra C

Exterior equipment and body parts
The Vectra-C/Signum load-bearing body is a welded structure consisting of a bottom group, sidewalls, roof, front and rear fenders. All body elements are...

Specifications of the body and its elements
Gap between adjacent body elements, mm Front: Wing - front door - 4.0 ±1.0 Wing - hood - 4.0 ±1.0 Trunk lid: Trunk lid - rear sidewalls (wings) 4.0 ±1.0 Trunk...

Removal and installation of side (door) trims (moldings)
1. Heat the molding with a hair dryer. 2. Carefully pry up the edge of the molding using a plastic wedge. Gradually move the wedge along the edge of the...

Removal and installation the fairing grille
1. Remove the windshield wiper arms ( see Chapter 12 ), open the hood, disconnect and remove the rubber seal from the rear bulkhead of the engine compartment...

Removal and installation the front bumper (bumper trim)
1. Remove the decorative radiator grille. 2. Disconnect the front wheel arch protection from the front bumper cover ( see Section 7 ), on diesel models,...

Removal and installation the rear bumper
GTC Sedan/Hatchback Models 1. Remove the rear combination lights ( see Chapter 12 ). 2. Remove the license plate light ( see Chapter 12 ). 3. Remove 6 mounting...

Removal and installation of wheel arch protection (fenders, mudguards)
Note: In the rear wheel arches, protection is installed only in the rear area of the arches. 1. Remove the appropriate wheel. 2. In the front wheel wells,...

Removal and installation front fenders
1. Remove the front bumper cover. 2. Remove the headlight, side turn signal repeater ( see Chapter 12 ) and wheel arch protection ( see Section 7 ) on the...

Removal and installation lower outer threshold trims
1. Open the front and rear doors on the corresponding side of the vehicle. 2. Using a plastic wedge, carefully remove the framing protective strip of the...

Removal and installation the hood, adjusting gaps and the hood lock
Removal 1. Open the hood and disconnect the gas-filled telescopic strut from it, for which slightly lift the locking bracket with a screwdriver and remove the...

Side rear view mirror — removal, disassembly, replacement
Removal the mirror assembly 1. Remove the front door triangle trim ( see Section 21 ). 2. Disconnect the mirror wiring connector (see accompanying...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: