Cooling and Ventilation Specifications System Type - Sealed (pressure above atmospheric), with expansion tank. The cooling system pump is driven by a timing belt. Coolant Type/Specification (all...
Cooling System — Fluid Drain 1. Having parked the car on a flat horizontal platform, remove the filler cap of the expansion tank. If the engine is hot, wrap a thick cloth around the filler...
Cooling system — flushing 1. If the liquid was not changed on time and if the concentration of antifreeze in it decreased, then the efficiency of the cooling system will gradually...
Cooling system — filling 1. Before filling the cooling system, check the condition of all hoses and their clamps. Note that antifreeze must be present in the system all year round to...
Coolant — general information 1. Antifreeze must be present in the cooling system all year round to prevent corrosion of engine components. The coolant should consist of clean, preferably...
Radiator — inspection and cleaning 1. If the radiator was removed due to a suspected blockage, flush it backwards as described in Chapter 3 . 2. Clean dirt and debris from the radiator fins...
Thermostat — removal and installation Note: When installing the thermostat, use a new O-ring. Models 1.4 and 1.6 l (except C16 NZ2) Removing 1. Partially drain the cooling system as described in...
Thermostat — check operation 1. A rough check of thermostat operation can be done as follows. Hang it on a piece of twine in a container filled with water. Heat the water to a boil - at...
Coolant pump — removal and installation Models with a single overhead camshaft engine Removing 1. If the engine is not removed from the vehicle, drain the liquid from the cooling system as described...
Fan — removal and installation Removing 1. Disconnect the negative cable from the battery. 2. Disconnect the wiring from the cooling fan, marking the location of the connector to facilitate...
Temperature gauge sensor — removal and installation Removing 1. The sensor is screwed into the intake manifold on models E4 and E6 (except C16 NZ2) and in the thermostat housing on models C16 NZ2, 1.8 and 2.0 l...
Fan switch — removal and installation Note: When installing the circuit breaker, use a new O-ring. Removing 1. The fan switch is installed in the lower right corner of the radiator (see...
Heater control panel — removal and installation Removing 1. Disconnect the negative cable from the battery. 2. Remove the passenger footwell trim, steering column shrouds, and instrument panel upper and...
Heater — removal and installation Removing 1. Drain the liquid from the cooling system ( Chapter 2 ). 2. Working in a motor compartment, disconnect hoses of a cooling liquid from branch pipes...
Heater blower motor — removal and installation Removing 1. The heater blower motor is located under the windshield fairing. 2. Remove the windshield fairing as described in Section 11. 3. Remove the wiper...
Panel deflectors — removal and installation Central deflectors Removing 1. Using a screwdriver as a lever, carefully remove the cover from the emergency stop switch. 2. Carefully remove the deflector...
Troubleshooting the cooling system Overheat Not enough coolant in the system ( Section 1 ) Thermostat defective ( Section 3 ) Clogged radiator core ( Section 3 ) Faulty cooling fan or...