Contents: Removal ⬇ Installation ⬇
Removal
1. Disconnect the negative cable from the battery.
2. Disconnect the electrical wiring from the cooling fan, marking the location of the connector to facilitate installation.
3. Remove the bolts securing the two upper corners of the fan shroud, then tilt the assembly slightly toward the engine, pull it up and off the radiator (see illustration).
4. To separate the fan motor from the shroud, remove the three mounting nuts. If necessary, separate the fan impeller from the motor by removing the spring clip from the end of the motor shaft.
5. The motor cannot be repaired, so if the unit is faulty, replace it.
Installation
6. Assembly (where possible) and installation is done in reverse order. Make sure the bottom edge of the fan shroud is correctly positioned on the radiator.
7. Finally, start the engine, let it warm up to normal operating temperature and check that the fan is working properly.
Visitor comments