Automatic car gearbox Opel Vectra B

General information about automatic transmission
The four-speed electronically controlled automatic transmission consists of a torque converter, epicyclic gear train and hydraulically controlled clutch and...

Technical specifications
Type with four forward gears and a reverse gear computer controlled motion Identification: – 1.6 liter engines AF13 – 1.8 and 2.0 liter engines AF20...

Gearbox oil change
1. Take the vehicle for a short drive to bring the transmission up to operating temperature. 2. Place the vehicle on a lift or over an inspection pit. 3....

Adjusting the selector lever
Warning! If the battery is disconnected with the selector lever in position P, the lever will be locked in this position. 1. To release the lever from the...

Selector cable — removal and installation
1. Remove the center console and set the selector lever to position P. 1 – mounting bracket 2. Using a thin screwdriver blade (indicated by the arrow) as a...

Selector lever — removal and installation
Removal and installation 1. Remove the center console and set the selector lever to position P. 2. Disconnect the electrical connectors from the selector lever...

Replacing the torque converter sealing ring
1. Remove the gearbox. 2. Slide the torque converter off the transfer shaft. 3. Mark the location of the O-ring in the oil pump housing and remove the O-ring....

Electrical transmission controls
Starter interlock and reverse light switch 1. Marking 2. Bolt 3. Gear selection mechanism shaft 4. Bolt Starter interlock and reverse light switch The starter...

Driving style switch — removal and installation
Removal 1. Remove the selector lever. 2. Remove the switch (2) from the top of the selector lever by pushing it with a long steel rod (1) through the hole in...

Electronic control device — removal and installation
The ECU is located in the front passenger footwell. Removal and installation 1. To access the ECU, remove the glove box. 2. Release the retaining clips and...

Gearbox input and output shaft sensors
Location of input shaft and driven shaft speed sensors The sensors are located on the top of the gearbox. The input shaft speed sensor is located closer to the...

Gearbox Oil Temperature Sensor
The temperature sensor is screwed into the base of the front of the gearbox. Removal 1. Remove the ground cable from the battery. 2. Raise the front of the...

Removal and installation of gearbox — removal and installation
Fastening oil cooler hoses to the gearbox on 1.6L engines 1. Hose 2. Mounting bracket 3. Gearbox nipple Location of oil cooler hoses on gearbox on 1.8 and 2.0...

Gearbox overhaul
The gearbox is a very complex unit and its repair must be carried out in a specialized workshop. Before repairing the gearbox, it is necessary to determine the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: