Clutch Specifications Type - Single disc, cable driven Friction disc diameter 14 NV - 190 mm 16 SV, C16 NZ, C16 NZ2 and 18 SV - 200 mm 318 NZ, 20 NE, C20 NE and 20 SEH - 216 mm 20...
General description of clutch 1. The clutch is of single disc type, consists of five main components: friction disc, pressure plate, diaphragm spring, casing and release bearing. 2. The...
Clutch cable — removal and installation Removing 1. Working in the engine compartment, measure the length of the cable protruding from the plastic tip (at the release lever) cutting rod. This will...
Clutch cable — adjustment Note: In 1989, some vehicles were produced with the wrong brake pedal height - approximately 15.0mm above the clutch pedal (standard setting - 4.0 mm lower)....
Clutch pedal — removal and installation Removing 1. Remove the clutch cable as described in steps 1 and 2 Chapters 2 . 2. While working inside, remove the driver's footwell lower trim panel. 3....
Release bearing and lever — removal and installation Note: If the release bearing drive sleeve is removed, a new O-ring must be used for installation. Removing 1. The release bearing can be accessed either by...
Clutch Troubleshooting The pedal fails - there is no or very little resistance Broken clutch cable ( Section 6 ) Incorrect clutch cable adjustment ( Section 6 ) Damaged release...