Electrical equipment of the car engine Opel Vectra C

Engine Electrical Specifications
Ignition system (petrol models) Type - Electronic with direct ignition (without distributor) Firing order: 4-cylinder engines - 1-3-4-2 (the first cylinder is...

Description of the design of the engine electrical equipment
General information and precautions 1. The engine electrical equipment includes components of the ignition systems (petrol models), preheating (diesel models),...

Main engine powertrain fault codes
P0000 No fault codes in system memory P0100 Malfunction in the mass air flow (MAF) sensor circuit P0101 Malfunction of MAP P0102 Excessively low signal level...

Ignition/Glow and Engine Management Systems
Note: Please also refer to Section " Troubleshooting ". General information 1. The ignition and fuel systems are interconnected components, so some components...

On-board diagnostic system OBD
Note: On models equipped with the OBD II self-diagnostic system, there should be an entry on the nameplate under the hood or on the bottom of the instrument...

Using an oscilloscope to monitor engine control system operating signals
Note: The material below is for descriptive purposes only and is not specific to any particular make or model of vehicle. General information 1. Digital...

Removal and installation of spark plugs, coils and ignition modules
Depending on the engine brand, 4 or 6 spark plugs will be required. Engine BOSCH spark plugs brand Interelectrode gap, mm Z20NET Z16XE with numbers up to...

Removal, installation and checking glow plugs
1. The main elements of a glow plug are the housing and the heating element pressed into it. Due to the good starting characteristics of diesel engines with...

Battery — Checking, Disconnecting, Removing and Selecting
Disconnecting the battery 1. When carrying out repair work, it is always recommended to disconnect the battery. In principle, if the battery needs to be...

Generator — Checking, Removing and Installing
General information 1. The vehicles in question use an alternator. When installing additional electrical equipment, check that the generator capacity is...

Removal and installation the voltage regulator, checking and replacing the generator brushes
Removal and installation the voltage regulator 1. Remove the generator ( see Section 10 ). 2. Loosen the 2 nuts, unscrew the screw and remove the protective...

Starter — removal, installation and testing
General information 1. The sole purpose of the starting system is to ensure that the engine rotates at a speed sufficient to start it - approximately 300 rpm....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: