Engine Electrical Opel Frontera A (Petrol)

Engine electrical equipment — general information
The engine electrical equipment includes all components of the ignition, starting and charging systems. Since these components are functionally related to...

Engine Electrical System Specifications
Note: Individual characteristics are also given in the text of the Chapter. Ignition system Ignition system With distributor (2.4 l) or without distributor...

Ignition system — general information
Depending on the engine type, year of manufacture, etc., the engine may have an ignition distributor or a four-terminal ignition coil. The latter scheme is...

Ignition system Bosch M1.5.4
Replacement of DIS ignition module (since mid-1995) The module is located on the back side of the engine, near the front wall. 1. Disconnect the cable with the...

Ignition system Bosch M1.5.4 for DOHC engine
Replacement of DIS ignition module The unit is located on the back of the engine near the front wall and can be found by the four ignition cables attached to...

Bosch Motronic M1.5 system for 2.0 and 2.4 l engines
The following instructions apply to the 2.0L engine before 1995 and the 2.4L engine. Removal and installation the ignition distributor Ignition distributor for...

Checking the ignition timing
Checking the ignition timing of a 2.0L engine manufactured before mid-1995 The ignition timing of the old 2.0L engine can be checked. To do this, you need to...

Spark plugs — general description
Interelectrode distance of spark plug "A" Spark plugs have a thread diameter of 14 mm. Manufacturers recommend a certain type of spark plug, but you can use...

Safety precautions when working with ignition system components
To avoid breakdown or damage to the ignition system, the following safety precautions must be observed during all work on the ignition system: 1. Do not...

Charging and starting systems — general information
All vehicles covered in this manual have a 12V electrical system. The ground connection is through the negative battery terminal. The battery is located in the...

Safety precautions when working with a generator and regulator
Safety precautions when working with a generator Before performing any work on the charging system, please read the following safety precautions: 1. Never...

Removal and installation the generator
For all versions, disconnect the ground cable from the battery. Further, depending on the design: Engine 2.0 l before 1995 1. The generator mount is shown in...

Bosch Generator Repair
Bosch Generator Assembly Diagram 1 - Tie bolt; 2 - washer; 3 - distance ring; 4 - bearing mounting plate; 5 - ring; 6 - distance ring; 7 - bolt and spring...

Starter — removal, installation and repair
Bosch starter assembly diagram 1 - lid; 2 - bushing; 3 - bearing housing; 4 - excitation winding; 5 - body; 6 - anchor; 7 - brush holder plate; 8 - brush...

Battery — Removal, Installation and Maintenance
The installed 12 V battery with a capacity of either Ah or, optionally, Ah consists of six cans containing positive and negative plates, which are immersed in...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: