Vehicle Steering Opel Frontera A (petrol)

Power steering — general information
All Frontera vehicles are equipped with a nut-and-screw steering system with recirculating balls and hydraulic power steering. Like other components of the...

Removal and installation the pendulum arm
A special puller is required to separate the steering ball joints. If the text says "remove the ball joint", this means that you need to unscrew the ball joint...

Steering knuckle and pendulum arm
Removal 1. Disconnect the center steering rod from the swing arm. 2. Disconnect the steering arm from the steering gear and the pendulum arm from the bracket...

Replacing outer tie rods and tie rod ends
Removal 1. Loosen the locknuts on the outer sides of the tie rod. The left-hand thread nut is marked "L". The location of the nuts is shown in the...

Removal and installation the steering wheel
Removal and installation of the steering wheel and column varies depending on the year of manufacture of the vehicle. First, you need to disconnect the ground...

Removal and installation the steering column
Removal It is necessary to distinguish between cars produced before and after 1997. 1. Disconnect the ground cable from the battery. 2. When removing the...

Replacing the steering lock and steering column bearing
Removal Parts can be replaced without removing the steering column. However, it is necessary to drill holes in the steering lock mounting bolts in order to...

Disassembly and assembly of the steering column
When disassembling the steering column, it is necessary to take into account the difference in the design of columns with a fixed and adjustable column height...

Steering gear — general information
Power steering reduces the effort required to turn the steering wheel by using fluid pressure energy. The hydraulic booster contains a piston with a segmented...

Removal and installation the steering gear
Removal 1. Loosen the union nuts and disconnect the pressure and drain hoses at the locations shown in the illustration. 2. Take appropriate measures to...

Removal and installation the power steering pump
Here it is also necessary to take into account the year of manufacture of the car, since depending on this, the work has some differences. The difference is...

Replacing the V-belt of the power steering pump drive
On new generation vehicles, the V-belt is removed and installed in accordance with the instructions given in Section 3 Chapter 3 . This applies to both OHC and...

Airbag — Removal and Installation
It is worth reminding once again that it is not recommended to remove the airbag yourself. However, here are some safety precautions to take when performing...

Steering wheel adjustment
Fine adjustment of the steering position is performed after installing the steering gear and steering rods or steering column. If the tie rods have been...

Adjusting the steering wheel free play
When the engine is running, the steering wheel should move to the right and left by 10 - 30 mm. If the play is greater than specified, you must adjust the...

Removal air from the hydraulic system
1. With the engine not running, unscrew the tank cap and fill the fluid up to the "Max" mark. 2. Wait at least two minutes for the fluid to fill the system. 3....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: