Car clutch repair Opel Frontera B

Technical data
Clutch technical data Clutch drive Hydraulic Type Dry with pressure plate and diaphragm spring Outer diameter of pressure plate, mm: - car with 6VD1-W engine...

General information
Warning! Clutch repair requires removal of the gearbox, so in this case it is also recommended to replace the clutch driven disc and clutch release drive. The...

Bleeding the hydraulic clutch drive system
Any hydraulic system will operate properly if the air is removed from it. Warnings: When removing air, add only clean fluid recommended by the manufacturer....

Clutch drive tube and hose
Removal Disconnect the hose from the clutch slave cylinder ( see the relevant chapter ). Remove the clamp securing the hose and tube connection to the bracket,...

Clutch master cylinder
Removal Use a syringe to suck out the fluid from the clutch hydraulic reservoir. Loosen the connecting nut securing the tube to the clutch master cylinder,...

Clutch slave cylinder
Removal Use a syringe to suck out the fluid from the clutch hydraulic reservoir. Loosen the connecting nut securing the tube to the clutch master cylinder,...

Checking and adjusting the clutch pedal
Disconnect the connector from the clutch pedal switch. Loosen the lock nut and, by turning the push rod (2), adjust the height (H) of the clutch pedal, then...

Clutch pedal and bracket
Removal Remove the lower cover from the instrument panel on the driver's side. Remove the screw and remove the driver's side air duct. Disconnect the connector...

Slave and pressure plates of the clutch
Clutch: A - push-type vehicles with engines X 22 SE and X 22 DTH; B - a towing type vehicle with a 6VDI-W engine Housing with pressure plate and clutch slave:...

Bearing and clutch release fork of push type
Removal Remove the gearbox ( see the relevant chapter ). Remove the locking pin, remove the pivot pin, remove the clutch release fork from the bracket and the...

Bearing and clutch release fork of pull type
Removal Remove the gearbox ( see the relevant chapter ). Remove the clamps securing the clutch release bearing housing to the fork. Pull towards the housing to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: