Removal and installation the door seal (Opel Vectra C)

1. Open the door and remove the seal from the door frame (see accompanying illustration).

41.1 Door seal (1): 2. Seal joints; 3. Inner edge

2. When installing the seal, place it on the edge of the door frame and press it firmly, gradually moving along the entire perimeter of the door opening. At the same time, make sure that the inner edge (see illustration 41.1) was located above the interior decoration.

Note: If there is damage, apply special rubber glue to the seal joints and press the ends of the seal together.

Text was copied from the portal: www.OPELBOOK.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Meshcheryakov Damir

Share information:

Opel Vectra C: Interior

Removal and installation steering column covers
Removal and installation the lower decorative cover of the instrument panel under the steering column
Removal and installation the side decorative panel of the console section of the instrument panel
Removal and installation the decorative strip of the instrument panel
Removal and installation the automatic transmission selector lever base cover
Removal and installation ashtrays

Removal and installation the interior sill trim panel
Removal and installation the front body pillar trim (A-pillar)
Removal and installation the trim of the central body pillar (B pillars)
Removal and installation rear body pillar trim (C and D pillars)
Removal and installation luggage compartment side trim
Removal and installation the rear luggage compartment shelf for hand luggage (Sedan models)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet