Vectra/Calibra cars
Removal
Remove the front bumper.
Remove the direction indicator.
Raise the hood. Protect the hood and hinges from damage with adhesive tape.
Loosen the nine bolts securing the front wing.
Remove 2 bolts from the outside of the front pillar.
On Calibra vehicles: partially release the protective apron.
Loosen the bolt at the bottom of the front pillar.
Remove the two bolts on the wheel arch bracket.
In Vectra vehicles: unscrew the headlight mounting bolt.
Loosen the wheel bolts, raise the vehicle and remove the front wheels.
(Text copied from an online resource: www.opelbook.ru)
Remove the wheel arch liner. To do this, remove the expansion sleeves. There are small pins in the sleeves that should be knocked out with a suitable punch. The pins can be reused.
Squeeze and remove the front wing from the body. Separate the sealing mass with a sharp knife or heat it with a hair dryer.
Installation
Clean the mating surface and cover with a layer of Opel sealant.
Install the wing, carefully fit it to the body and secure it.
Apply a protective coating to the inner surface of the wing.
On Calibra vehicles: secure the protective apron.
Insert the insert and secure it with expansion bushings by driving pins into them.
Tighten the protective casing nuts.
Install the direction indicator.
Install the front bumper.
Visitor comments