Exterior (external elements) of car Opel Corsa C

Car body specifications
Gaps between adjacent body elements, mm Front: Wing - front door - 4.0±1.0 Wing - hood - 4.0±1.0 Tailgate: Tailgate - rear sidewalls (wings) - 4.0 + 1.0...

General information about the car body
The load-bearing body of the Corsa C/Meriva is a welded structure consisting of a bottom group, sidewalls, roof, front and rear wings. All body elements are...

Minor damage to windshield caused by stone impact
Despite the apparent insignificance of such damage, over time they can create significant problems - gradual expansion of the damaged area, deterioration of...

Removal and installation the lower spoiler (Corsa Eco models)
1. Jack up and place the rear of the vehicle on stands (see Chapter " Introduction "). 2. Remove the retainer (A), loosen the 2 front nuts, unscrew the 2...

Removal and installation the engine compartment bulkhead cover (Meriva)
1. Open the hood and remove the rubber seal from the upper edge of the engine compartment bulkhead cover (see accompanying illustration). 4.1. Removing the...

Removal and installation of side (door) trims (moldings)
1. Heat the molding with a hair dryer. 2. Carefully pry up the edge of the molding using a plastic wedge. Gradually move the wedge along the edge of the...

Removal and installation the fairing grille
Corsa Models 1. Remove the windshield wiper arms ( see Chapter 12 ), open the hood, disconnect and remove the rubber seal from the rear bulkhead of the engine...

Removal and installation the front bumper and bumper cover
Corsa Models 1. Disconnect the fog light connector and open the hood. 2. First turn out the top 3 (see illustration 7.2a), and then the 4 lower ones (see...

Removal and installation the rear bumper and bumper cover
Corsa C models 1. Loosen the 4 plastic nuts securing the right and left rear wheel arch protection (see accompanying illustration). 8.1. Plastic nuts...

Removal and installation of wheel arch protection (lockers)
Note: In the rear wheel arches, protection is installed only in the rear area of the arches. 1. Remove the appropriate wheel. 2. In the front wheel well on...

Removal and installation front fenders
Corsa Models 1. Remove the front bumper cover ( see Section 7 ). 2. Remove the side turn signal repeater ( see Chapter 12 ) and wheel arch protection ( see...

Removal and installation the wheel arch molding (Corsa)
Note: The following describes the removal/installation of the front wheel arch trim. The rear trim is removed/installed in a similar manner. 1. Disconnect the...

Removal and installation lower outer threshold trims
1. Open the front and rear doors on the corresponding side of the vehicle. 2. Remove the expansion rivets and remove the rear cover from the threshold channel...

Removal, installation and adjustment of the hood
Note: The procedure for removing/installing and adjusting the bonnet is described below using the Corsa model as an example. On Meriva models, these procedures...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: