Repair of engines 1.4/1.6/1.8 l car Opel Corsa C (petrol)

Technical characteristics of gasoline engines
Test and adjustment values - DOHC-I (1.4L engine) Test and adjustment values - DOHC-I (1.6L engine) Test and adjustment values - DOHC-I (1.8L engine) Poly...

Test values for engines
Test values for all engines see table below. Toothed belt (1.6L engine) * Mark the belt replacement date on the sticker. Toothed belt (1.8L engine) * Mark the...

Checking engine pressure loss (1.4-1.6L engines)
Removal the air filter housing Note: Before the inspection procedure, warm up the engine to operating temperature (oil temperature – 80°C). Open the hood....

Checking engine pressure loss (1.8L engine)
Removal the air filter housing Open the hood. Components removed when dismantling the air filter: 1 – mounting bolt; 2 – intake manifold; 3 – Mass air flow...

Checking engine compression
Note: Before the inspection procedure, warm up the engine to operating temperature (oil temperature – 80°C). Removal the ignition module Remove the ignition...

Checking engine tightness (CO content in the cooling system)
Note: Before the inspection procedure, warm up the engine to operating temperature (oil temperature – 80°C). Caution: Remember that the cooling system is under...

Measuring oil consumption
Oil consumption of an internal combustion engine refers to the amount of oil consumed as a result of the combustion process. Oil consumption should not be...

Removal and installation the flywheel (1.4L engine)
Removal Remove the gearbox. Remove the clutch housing assembly. Disconnect the flywheel. Removing the flywheel: 1 – flywheel; 2 – special device; 3 – mounting...

Replacing the rear crankshaft oil seal
Removal Remove the flywheel. Remove the plastic ring with a screwdriver. Removing the plastic ring: 1 – plastic ring; 2 – screwdriver Note: Make holes in the...

Replacing valve stem seals (installed cylinder head)
Removal Remove the camshafts. Remove the spark plugs using the special tool KM-194-E. Raise the car. Remove the right engine splash shield. Make a timing mark...

Checking the axial free play of the crankshaft
Note: The test is carried out with the bearings installed and the flywheel removed. The crankshaft is freely installed in the cylinder block. Measure the axial...

Removal and installation the cylinder head (1.4-1.6 l engine)
Note: Before the inspection procedure, warm up the engine to operating temperature (oil temperature – 80°C). Removal Open the hood Remove the air filter...

Checking the clearance in the connecting rod bearing
Measurement Install the connecting rod bearing cap (3) with the connecting rod bearing shells (2) onto the connecting rod. Note: Do not change the connecting...

Replacing the connecting rod bearing
Remove the oil pan. Mark the order of the connecting rod bearing caps. Disconnect the connecting rod bearing caps from the connecting rods. Note: The contact...

Replacing piston rings
Remove the piston with the connecting rod. Use piston ring pliers to remove the piston rings. Clean the ring grooves. Clean the piston ring grooves of the...

Replacing the piston with the connecting rod
Note: If one of these two elements needs to be replaced, all units of the block must be replaced (piston, piston rings, piston pin and connecting rod) new...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: