Contents: Removal ⬇ Installation ⬇
Removal
Remove the gearbox.
Remove the clutch housing assembly.
Disconnect the flywheel.
Removing the flywheel: 1 – flywheel; 2 – special device; 3 – mounting bolts
Note: Special tool KM 6263 remains on the engine.
Lock the flywheel using the special tool KM 652.
Unscrew the 6 mounting bolts.
Check the rear crankshaft oil seal, flywheel and flywheel ring gear for damage or wear, replace if necessary.
Clean the contact surfaces of the crankshaft and flywheel.
Installation
Install the flywheel onto the crankshaft.
Lock it using the special device KM 652.
Clean 6 threads.
Tighten 6 bolts (3) to 35 Nm, turn further by +30°.
Flywheel installation: 1 – flywheel; 2 – special device; 3 – mounting bolts
Note: Please use new bolts when installing.
Apply (red) thread locking compound.
Install the clutch housing assembly.
Install the gearbox.
Visitor comments