Repair of engines 1.0 and 1.2 l car Opel Corsa C (petrol)

Engine number
The engine number (arrow) is located on the transmission side under the oil filter housing on the cylinder block. Note: When installing a replacement engine,...

Checking oil pressure (Z10XE, Z10XEP)
Note: The engine must be warmed up (oil temperature min. 80°C) before performing the inspection procedure. Verification procedure Open the hood. Remove the oil...

Checking engine compression (Z10XE, Z10XEP)
Verification procedure Open the hood. Remove the air filter housing 1. To do this, disconnect 2 wiring harness connectors, hot-film air flow meter 3, tank...

Checking the valve timing (Z10XE, Z10XEP, without air conditioning)
Open the hood. Disconnect the battery terminals. Note: On vehicles from year 04 with ESP - after each battery disconnection the steering wheel angle sensor...

Compression pressure test (Z10XE, Z10XEP, with air conditioning)
Note: The engine must be warm (oil temperature min. 80°C). Verification procedure Open the hood. Remove the ignition module. Remove the ignition module cover...

Checking fuel pressure (Z10XE, Z10XEP, with air conditioning)
Verification procedure Open the hood. Install the fuel pressure gauge KM-J-34730-91. Unscrew the protective cap of the control nipple 2 on the fuel distributor...
There is 1 comment

Adjustment of valve timing by acting on the camshaft Z10XEP, Z12XE, Z14XEP (from the end of 2004 to 2005)
Compared to the end of 2004, the manufacturing method of the camshaft drive gears and the crankshaft timing gear for the above-mentioned engines has changed....

Adjustment of valve timing (Z10XE, Z10XEP, without air conditioning)
Open the hood. Disconnect the battery terminals. Note: On vehicles from year 04 with ESP - after each battery disconnection the steering wheel angle sensor...

Replacing the poly V-belt (Z10XE, Z10XEP, with air conditioning)
Note: Starting from year 04, KM-6394 must be used instead of KM-6169-1. Removal Open the hood. Disconnect the battery terminals. Note: On cars from year 04...

Cylinder head
For reference and repair values, see table below. Note: Cylinder head turning is not permitted. Reference and repair values Reference and repair values...

Removal and installation of the timing case (Z10XE, Z10XEP)
Note: Starting from year 04, KM-6394 must be used instead of KM-6169-1. Removal Open the hood. Disconnect the battery terminals. Note: On vehicles from year 04...

Engine repair (Z10XE, Z10XEP, without air conditioning)
Removal Remove the gearbox from the engine. Remove the oil dipstick guide tube. Remove the bolt. Remove the heated lambda fuel ratio sensor. Disconnect the...

Cylinder block, crank mechanism and piston group
Note: After drilling, the old reference value must be made invalid and a new excess control value must be knocked out. Note: After drilling, make the old...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: