Checking fuel pressure (Z10XE, Z10XEP, with air conditioning) (Opel Corsa C)

Verification procedure

Open the hood.

Install the fuel pressure gauge KM-J-34730-91.

Unscrew the protective cap of the control nipple 2 on the fuel distributor pipe.

Note: The test nipple on the Z10XEP engine is located on the top of the fuel rail.

Start the engine.

Bleed the air from the fuel pressure gauge.

Read the fuel pressure reading on the pressure gauge.

Set value: 380 kPa (3.8 bar).

Stop the engine.

Reduce the fuel pressure on the fuel pressure gauge.

Collect any leaking fuel in a suitable container.

Remove the fuel pressure gauge KM-J-34730-91.

Screw on the protective cap of the test nipple.

Close the hood.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Kornev Georgy

Share information:

Opel Corsa C: Engine repair

Compression pressure test (Z10XE, Z10XEP, with air conditioning)
Checking the valve timing (Z10XE, Z10XEP, without air conditioning)
Checking engine compression (Z10XE, Z10XEP)
Checking oil pressure (Z10XE, Z10XEP)
Engine number

Adjustment of valve timing by acting on the camshaft Z10XEP, Z12XE, Z14XEP (from the end of 2004 to 2005)
Adjustment of valve timing (Z10XE, Z10XEP, without air conditioning)
Replacing the poly V-belt (Z10XE, Z10XEP, with air conditioning)
Cylinder head
Removal and installation of the timing case (Z10XE, Z10XEP)
Engine repair (Z10XE, Z10XEP, without air conditioning)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

Oleq написал(а) 12.06.2022 в 22:01:

3.8бар,а насос новый по вину предлагают 3.0бар,яне понимаю, может ли насос на 3.0бара выдать 3.8?

ответить цитировать