SOHC gasoline engines Opel Corsa B

Specifications of all engines
General parameters A complete list of engines and their parameters used to equip Opel Corsa-B/Combo and Tigra models. Volume, cm³ X10XE Engine 973 Engine X12SZ...

General information about all engines
The Opel Corsa/Combo and Tigra model range is distinguished by an extremely wide range of engines offered to consumers. The full list of engines used to equip...

Checking the compression pressure in the cylinders and engine oil parameters
Checking the compression pressure in the cylinders The results of the cylinder compression test allow you to determine the overall condition of the upper...

Engine condition diagnostics using a vacuum gauge
Using a vacuum gauge at a relatively low cost allows you to obtain fairly comprehensive information about the internal condition of the engine. Based on the...

Bringing the piston of the first cylinder to the position of the top dead center of the compression stroke (TDC)
General information Top dead center (TDC) is the highest point of the piston stroke in its cylinder. Strictly speaking, in 4-stroke engines, during the...

Removal and installation the timing cover
Removal 1. Remove the intake air duct cover from the throttle body cover (see Chapter Fuel, exhaust and emission control systems ). 2. Loosen the mounting...

Removal and installation the crankshaft pulley
Removal 1. Set the parking brake, jack up the front of the car and place it on stands. Remove the right front wheel and (with appropriate equipment) crankcase...

Removal and installation the timing belt cover
Removal Upper section 1. Remove the air cleaner (see Chapter Fuel, exhaust and emission control systems ). 2. Remove the mounting screws and remove the upper...

Removal and installation the timing belt
The timing belt must be removed on a cold engine! Do not turn the engine with the timing belt removed! Removal 1. Disconnect the negative cable from the...

Removal and installation timing gear wheels
Camshaft gear Removal 1. Remove the timing belt (see section Removal and installation the timing belt ). 2. Block the camshaft from turning when releasing the...

Replacing the camshaft seal
1. Remove the camshaft timing gear (see section Removal and installation timing gear wheels ). 2. Carefully punch or drill a couple of small holes in the hard...

Removal, condition check and installation of the camshaft with the timing mechanism housing
Removal Removal using a device If a special device is available, the camshaft can be removed from the engine without first dismantling the valve timing...

Removal, inspection and installation of valves
Removal 1. Remove the timing case 2. Prepare 8 clean plastic bags or plastic cups, labeling them in the order of the valve numbers (you can also use a large...

Removal and installation the cylinder head
Proceed with the work only after the engine has completely cooled down! Removal 1. Disconnect and remove the battery (see Chapter Engine electrical systems )....

Removal and installation the oil pan
Removal 1. Disconnect the negative cable from the battery. 2. Set the parking brake, then jack up the front of the vehicle and place it on supports. If...

Removal, maintenance and installation of the oil pump
Removal The pressure reducing valve can be removed without prior dismantling of the pump assembly. 1. Remove the timing belt (see section Removal and...

Removal, checking condition and installing flywheel/drive disk
Removal Models with manual transmission 1. Remove the transmission (see Chapter Manual 5-speed gearbox or Automatic 4-speed transmission ) and clutch (see...

Replacing crankshaft seals
Right (from the timing drive side) gland 1. Remove the crankshaft timing gear (see section Removal and installation timing gear wheels ). 2. Carefully drill or...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: