Removal and installation the instrument panel (Opel Kadett D)

Removal

Disconnect the ground wire.

Remove the speedometer shaft. To do this, press the locking spring down under the instrument panel at the back and remove the shaft at the same time.



In cars with partitions between the instruments, remove the light switch and the partition (arrow). To do this, push the light switch out of the instrument panel from the back.



Unscrew the instrument panel housing from the body (arrow).

Pull out the instrument panel housing.

Press the locking springs of the multi-pin plug and disconnect the plug from the conductive board.

If necessary, additionally disconnect the terminals of the control lamps.

Remove the instrument panel housing.

Installation

Connect all electrical wires to the instrument panel housing.

Install the instrument cluster housing and secure it to the instrument cluster with one screw.

In cars with partitions between the instruments and the light switch, secure the partition with two screws and install the light switch on the instrument panel.

Install the tachometer shaft into the tachometer from the rear.

Connect the ground wire.