Removal and installation of a forward seat You will need: TORX T50 wrench, socket «on 10». Note. The work is shown for the left seat, the right seat is removed in the same way. 1. Disconnect the wire...
Removal and installation of a back seat The rear seat consists of a cushion and backrest, which in turn consists of two parts that can only be removed together. You will need a key «at 15». 1. Grasp...
Removal and installation of floor tunnel lining You will need: end head «on 7», flat and Phillips screwdrivers. 1. Disconnect the wire from the terminal «minus» battery. 2. Push down the latch on the lower...
Removal and installation of an internal mirror You will need a TORX T25 key. 1. Remove both halves of the lining of the interior mirror bracket, overcoming the elastic resistance of their latches. 2. Turn...
Design features of the instrument panel Dashboard installed on car (pic. 1) collapsible design, consisting of the actual decorative panel and frame. Pic. 1. Dashboard: And – a zone of installation of...
Removal and installation of glove boxes You will need: end head «on 7», flat blade screwdriver. For removal right glove box do the following. 1. Pry off the edge of the right instrument panel trim.....
Replacing handrails in the cabin You will need: flat head screwdriver «for 8». 1. Tilt the handrail down, overcoming the force of its return springs. 2. Prying off the plug with a...
Replacing sun visors You will need: flat blade screwdriver, TORX T15 wrench. 1. Rotate the canopy to expose the bracket attachment point. 2. Use a screwdriver to pry off the edge...