General information The vehicles are equipped with a transverse gearbox with a main gear and a differential, the crankcase is cast from an aluminum alloy. The gearbox mechanism...
Changing the oil in the gearbox 1. It is advisable to change the oil immediately after a trip so that the engine and gearbox are warmed up to operating temperature. 2. Park the vehicle on a...
Gear change mechanism — adjustment 1. Adjustment of the mechanism is necessary in cases of a removed gearbox or difficult gear shifting. 2. Loosen the clamp bolt, which is located in front of...
Gear change mechanism — removal and installation Shift Lever and Gear Select Shaft 1. Raise the front of the vehicle and place on stands. Remove the lower engine/gearbox guard. 2. Mark the position of the...
Gearbox seals — replacement Axle oil seal 1. Raise the rear of the vehicle and place on stands. 2. Drain the gearbox oil (see above). 3. Remove the half shaft ( Chapter 8 ). 4. Carefully...
Gearbox — removal and installation 1. Raise the front of the car and place it on stands. Remove the front wheels. Remove the lower engine protection panel, air filter and air ducts. 2. Drain the...
Gearbox disassembly — general information Self-repair of the gearbox is not recommended, as certain qualifications and special tools are required (hydraulic press, various pullers, micrometer heads and...
Gearbox — checking the oil level 1. Install the car above the inspection hole, or drive into the flyover. 2. The oil level is checked no earlier than 5 minutes after the trip. 3. The oil level...