Axle shaft seal
1. Raise the rear of the vehicle and support it on stands.
2. Drain the oil from the gearbox (see above).
3. Remove the axle shaft (Chapter 8).
4. Carefully remove the seal by prying it with a screwdriver (see photo).
5. Wipe the surface and use a mandrel to press in the new seal so that the seal surface is flush with the seal housing (see photo).
6. Install the axle shaft, fill the gearbox with oil.
Primary shaft seal
7. The primary shaft seal is made integral with the clutch slave cylinder, which is a non-separable structure. In case of leakage from under the seal, the clutch slave cylinder should be replaced.
Gear selector shaft seal
8. The gear selector shaft seal is changed at a car service center, since partial disassembly of the gearbox is required.
Visitor comments