General information about suspension and steering Front suspension design 1 — The top support of a rack 2 - Vertical thrust (rack) anti-roll bar 3 — a bar of the stabilizer of cross stability 4 - Drive shaft 5...
Suspension and steering specifications Common parameters suspension type Front suspension Independent, with MacPherson struts, gas-filled shock absorbers and anti-roll bar Rear suspension...
Removal and installation of a rotary fist The compilers of this Guide recommend replacing the steering knuckle bolts and nuts, regardless of their condition. To perform the procedure, you will need a...
Checking the condition and replacing the hub assembly Examination 1. Apply the parking brake, jack up the front of the vehicle and place it on jack stands. Manually rotate the wheel, listening for the sounds made...
Removal and installation of the front subframe Specialists of Opel branded service stations use special conductors to combine the power unit with the subframe. If such devices are not at hand, then before...
Removal and installation of the front anti-roll bar The compilers of this Guide recommend replacing all threaded fasteners without fail. Removing 1. Remove the front subframe (see Removal and installation of the...
Replacing the lower ball joint The ball joints are riveted to the lever at the factory. Bolts are used to fasten the interchangeable supports. 1. Remove the lower suspension arm (see...
Removal and installation of the rear hub assembly You will need new nuts securing the hub to the trailing arm. Rear wheel hub assembly mounting nuts and ABS sensor wiring Arrows — Nuts of fastening of stupny...