General information
This system is installed on Wagon models and provides the possibility of adjusting the ground clearance of the rear axle of the car depending on the degree of its loading. Adjustment is made by adjusting the air pressure in the rear shock absorbers through a control valve installed on the right in the luggage compartment.
For safety reasons, the air in the working path of the system should not be under maximum pressure if the vehicle is not fully loaded.
Adjustment
1. Unload the car and measure the pressure in the system with a tire pressure gauge. The nominal pressure is 0.8 bar. Make appropriate adjustments if necessary.
The system pressure must never fall below 0.8 bar!
2. Park the vehicle on a level surface, preferably paved, and measure the distance I from the top edge of the rear bumper to the ground. Subtract 50.0 mm from this value and record the result.
3. Put the prepared luggage into the car, if necessary, correct the pressure in the system, achieving the required value described in the previous measurement paragraph.
Do not increase the pressure in the system path above 5.0 bar!
4. After unloading the car, do not forget to relieve the pressure to the nominal level (0.8 bar).
Visitor comments