Lighting and signaling Opel Astra J (petrol)

Construction of lighting, light and sound signaling
Headlights. Opel Astra J cars are equipped with headlights that combine low and high beam headlights (with single-filament halogen lamps or, upon request, with...

Checking and adjusting headlights
Check and adjust the headlights on a loaded vehicle (with a full fuel tank, tool kit and spare tire). Attention! Do not neglect the work on adjusting the...

Replacing lamps
To replace lamps headlights perform the following operations. Note: Shown is replacement of the left headlight bulbs. The bulbs in the right headlight are...

Removal and installation the electrical equipment control unit
You will need a flat-blade screwdriver. To replace the electrical equipment control unit, installed in the trunk , perform the following operations. 1....

Headlight replacement
The headlight unit is removed for replacement in case of damage, malfunction of the electric light corrector, or to gain access to other components. You will...

Replacing the side turn signal light
1. Disconnect the wire from the negative terminal of the battery. 2. Move the turn signal light forward… 3. …and remove it from the wing. 4. Turn the lamp...

Replacing the rear light located on the tailgate
You will need: 8 mm socket head, flat blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry it up with a screwdriver… 3....

Replacing the rear light located on the wing
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the left trunk trim. 3. Unscrew the special plastic nut that secures the light… 4....

Replacing an additional brake light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry it up with a screwdriver and, overcoming the...

Replacing license plate lights
The license plate lights are mounted in the upper part of the license plate recess in the rear bumper. You will need a flat-blade screwdriver. 1. Disconnect...

Replacement of interior lighting lamps
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Use a screwdriver to pry up the edge of the...

Replacement of the trunk light
You will need: 8 mm socket head, flat blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Use a screwdriver to pry up the...

Replacing the fog light and turn signal unit
You will need: tORX T20 key, flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see Removal...

Replacing the glove compartment light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Open the glove compartment. 3. Pry up the edge of...

Replacing steering column switches
You will need: tORX T20 key, flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the steering wheel (see...

Removal and installation the horn
You will need: keys "10", "13". 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see Removal and installation the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Пакеты для мусора опт

Share information: