System check
1. Place the vehicle on a level surface and start the engine.
2. Measure the rear suspension height.
3. Place a heavy load in the trunk and check that within about 20 seconds the suspension height returns to its original value of 3–5 cm.
4. Remove the load and check that the suspension height returns to its original value.
Compressor
Removal
1. Remove the right front wheel arch insert.
2. Disconnect the compressor connection connector.
3. Disconnect the hoses, unscrew the mounting screws and remove the compressor.
Installation
Installation is carried out in the reverse order of removal.
Connecting tube
Removal
1. Disconnect the tube from the compressor and from the valves on the shock absorbers.
2. Disconnect the tube from the tee.
3. Remove the tube from the mounting clamps and remove it from the vehicle.
Installation
Installation is carried out in the reverse order of removal.
Rear suspension height sensor
Removal
1. Disconnect the sensor connection connector.
2. Disconnect the connecting link from the ball joint on the sensor arm.
3. Loosen the mounting screws and remove the sensor.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments