Removal and installation the rear suspension spring (Corsa and Tigra models) (Opel Corsa B)

1. Jack up the car and place it on supports.

2. Jack up the right rear shock absorber support

3. Unscrew the lower bolt securing the right shock absorber and push it away from the support.

Lower shock absorber mounting nut



4. If necessary, disconnect the brake hoses from the underbody. If equipped, disconnect the spring of the pressure regulator valve in the hydraulic circuits of the rear wheel brake mechanisms (see Chapter Vehicle settings and routine maintenance).

5. Slowly lower the jack, place it under the support of the left rear shock absorber and lift it slightly.

6. Disconnect the left shock absorber and press its supports.

7. Slowly lower the rear axle and remove first the right, then the left spring.

8. Remove the lower and upper spring damping rings.

[Text copied from an internet website opelbook.ru]

9. Check the wear of the damping rings.

10. Installation is carried out in reverse order.

Make sure that the springs are installed correctly: the hole with the smaller diameter should be facing upwards.

Correct installation position of the spring