General description The engine is a 4-cylinder, in-line with one overhead camshaft, traditionally installed on the front side of the car. Light alloy cylinder head and cast iron...
Technical service 1. Perform the following procedures at the intervals given in Section « Maintenance » at the beginning of this guide. Inspection/replacement of the timing belt...
Basic Operation Requiring Engine Removal The following actions are possible only after removing the engine: (A) Removal and installation of crankshaft and main bearings.
Engine removal method Although the engine can be removed with a manual or automatic transmission, it is recommended to remove the engine separately. The engine is removed from the...
Engine — removal 1. Remove the hood as described in Section 11 . 2. Disconnect the negative battery cable. 3. Remove the air filter on carbureted models, or disconnect and...
Engine Disassembly — General Description The engine must be disassembled in a clean room. It is advisable to have suitable containers for storing small parts, this will help when assembling the...
Auxiliary parts of the engine — removal Although the listed parts can be removed without removing the engine, we recommend removing them after removing the engine from the vehicle: Carburetor or fuel...
Engine — complete disassembly 1. Using a screwdriver, remove the distributor plate seal from the rear of the camshaft housing (photo). 2. Unscrew and remove the oil pressure sensor (photo)....
Engine mounting brackets — replacement 1. Apply the handbrake. Jack up the front of the car, secure it on axle stands. 2. Remove the nuts from the top of both engine mount brackets. 3. Use a winch...
Engine Components — Inspection and Rebuild Oil pump 1. Remove the connecting rod head screws, remove the back cover (photo). 2. Use a feeler gauge to check the backlash of the two gears, then check the...
Cylinder head — bulkhead 1. Clean the outer surfaces of the cylinder head. 2. Remove the valves by compressing the valve spring with the extractor and lifting the valve locks. Release...
Engine — Assembly 1. Place the cylinder block upside down on a bench, wipe down the seats of the main bearing frame. 2. Insert the main bearing shells into the crankcase, the...
Engine Accessories — Installation See Chapter 8 and install the listed components, referring where necessary to the indicated Sections.
Engine — Installation Engine installation is carried out in the reverse order to the removal of the sequence given in Chapter 6 , but in addition, do the following: a) Lightly...
Engine — preparation for launch after overhaul 1. Make sure the battery is fully charged and that all lubricants are cooled. fluid and fuel are topped up. 2. Double check all joints and connections. 3....