Front doors
1. In order to gain access to the handle, remove the door lining panel and the insulating plastic membrane (see Removal and installation of interior trim panels). Remove a back directing trench of a door glass.
2. Through the hole in the inner panel of the door frame, disconnect the rods going from the handle to the off button and the lock hook - the rods are fastened with plastic clips.
3. Give two fixing nuts and take a case plate from a door frame.
4. Carefully remove the outer door handle.
5. Installation is carried out in the reverse order. Before installing the inner door trim, check that the handle is working correctly, - if necessary, adjust the length of the drive rods by turning the plastic adjusting wheel.
Rear doors
1. In order to gain access to the handle, remove the door lining panel and the insulating plastic membrane (see Removal and installation of interior trim panels).
2. Through the hole in the inner panel of the door frame, disconnect the lock rod from the handle - the rod is fastened with a plastic retainer.
3. Give two fixing nuts and take a case plate from a door frame.
4. Carefully remove the outer door handle.
5. Installation is carried out in the reverse order. Before installing the inner door upholstery, check that the handle functions properly.
Visitor comments