Removal and installation the outer door handle (Opel Corsa B)

Removal

1. Remove the door trim.

2. Remove the protective film. Make sure that the film does not tear. Seal or replace torn film.

3. Remove the rear glass guide mounting bolts and detach the rubber seal.

Glass guide mounting screws



4. Pull the guide down.

5. Remove the two nuts (arrows).

Nuts for fastening the handle (arrows), lock rod (2) and brackets (1)



6. Disconnect the rod (2) from the door lock.

7. Disconnect the second rod (lock cylinder drive). To do this, turn the plastic clamp and disconnect it from the rod. Remove the rod from the clamp hole.

8. Press the two brackets (1) with a screwdriver and remove the door handle.

9. Remove the anti-theft alarm switch retaining clip (with appropriate equipment) and the switch itself.



Anti-theft alarm switch

Installation

1. Insert the handle into the door. When installing the handle into position, guide the rod (3) of the outer handle towards the intermediate plastic element.

Bracket (1), lock cylinder rod (2) and door handle rod (1)



2. Secure the handle with two nuts.

3. Connect the rod (2) of the lock cylinder and fix the bracket (1) on the rod.

4. Insert the anti-theft device switch (with appropriate equipment) with a bracket.

5. Check the operation of the handle and the single lock.

6. Apply the protective film.

Use double-sided film if necessary.

7. Replace the door trim.