Removal and installation front door glass (Opel Corsa B)

Removal

1. Remove the door trim with the sealing film. Be careful not to tear the film, otherwise it will need to be replaced.

2. Close the window completely. Mark the position of the glass guide mounting screws.

Corsa and Combo models

1. Loosen the screws securing the glass guide (arrows) and remove the rubber seal. Remove the guide downwards.

Glass guide mounting screws



2. Roll the glass down as shown in the accompanying illustration.

Glass guide (1), window lifter sliders (2) and its guide mounting bolts (3)



3. Unscrew the bolts securing the window regulator guide (3) models from 09.1993 unscrew the guide mounting screws and remove it with the rubber seal.



4. Remove the window regulator sliders (2) from the glass guide (1).

Model Tigra

1. On the Tigra model, remove the fasteners of the front and rear window guides. Pull the window regulator sliders out of the front guide.

Fastening glass guides

All models

1. Tilt the window forward and pull it up and out of the door.

[Material copied from this website: OpelBook]

Installation

1. Insert the window glass from above into the window shaft.

2. Insert the scissor window regulator sliders into the guide.

3. Attach the guide according to the marks you have set. If necessary, adjust the window position before tightening the bolt. To do this, use the bolts and pull the window up and down. The window will automatically fall into place, then tighten the bolts.

4. Insert the rear guide and screw it in. Press the sealing rubber.

5. Install the door trim.

6. Install the electric window lift. To do this, close all the doors and turn on the ignition. Close the windows with the button. Hold the button down in the closed window position for at least 2 seconds.