Cars produced since 09.1998 may be equipped with a side airbag built into the sides of the driver's and front passenger's seat backs. Seats with a side airbag are marked with white stripes with the red inscription "AIRBAG". The airbag sensor is located on each side behind the door trim. On cars equipped with side airbags, observe safety regulations when working with side airbag components and emergency belt tensioners.
Removal the front door trim (all models)
1. Carefully detach the inner door handle cover. Detach the handle (arrows). Disconnect the tweeter connector (1).
Handle mounting bolts (arrows) and tweeter connector (1)
2. Press out the outside mirror electric adjuster switch from inside the driver's door, disconnect its connector and remove the switch.
Removal the electric outside mirror adjuster switch
3. Loosen the door pocket mounting bolts and use a wide screwdriver to press the two fasteners. If equipped, disconnect the electric window switch wiring connector and remove the door pocket.
Door pocket fastener
A — Combo
B — Sedan
4. On the model Combo press the clips of the triangular cover of the outside mirror away from the door frame at its top.
Outside Mirror Trim Fasteners
5. If equipped, remove the front door window handle. To do this, press the wire clamp with the OPEL-KM-317-A tool. You can also use the HAZET-799 pliers. If the above tools are not available, press the clamp with a narrow screwdriver in the direction of the arrow.
Removal the front door glass movement handle
6. Remove the handle from its axis. If the spring was completely pressed out during removal, press the spring back into the handle groove. Remove the plastic washer.
7. Remove the inner seal of the front door glass using a plastic spatula.
Removal the inner glass seal
8. On models Corsa and Combo unscrew the bolts (arrows).
Trim fastening bolts (corsa and Combo models)
9. On the model Tigra remove the three bolts from the bottom edge of the door. Use a plastic spatula to separate the trim from the door at the back and front, opening the fasteners.
Bolts and trim fasteners (tigra model)
10. Remove the trim upwards through the door lock button.
11. If necessary, carefully remove the sealing film from the door frame. First, press the clamps (arrows).
Sealing film fasteners
Removal the rear door trim (corsa models)
1. Disconnect the inner door opening handle cover (3), unscrew the mounting screws and remove the rear door handle (1).
Components that interfere with the removal of the rear door trim
2. Remove the rear door glass movement handle (2).
3. Remove the triangular trim at the rear of the door.
Removal the triangular overlay
(Material copied from this portal: OpelBook.ru)
4. Unscrew the mounting bolts (arrows) and remove the trim upwards.
Trim fastening bolts
5. Remove the inner rear door glass seal upward.
Installation
1. Carefully stick the sealing film to the door frame. Seal any gaps with tape.
On vehicles with a side airbag, replace the damaged film. It is essential for the correct operation of the side airbag.
2. Connect the wiring connectors of the outside mirror and window regulator switches (with appropriate equipment).
3. Put the upholstery on through the power button, align it with the door frame and secure it.
4. Secure the door pocket with screws.
5. Secure the door handle. Connect the tweeter connector.
6. When manually operating the door glass, place a plastic washer on the handle axis with the high side facing the trim.
7. Place the door glass movement handle on the axis and slam it with your hand. The spring lock should enter the groove on the axis. The handle should be facing down when the window is closed.
8. Press the inner glass seal.
9. Secure the triangular trim and door handles.
Visitor comments