Removing
1. Front doors: remove the door mirror mounting trim (1).
2. Using a small flat screwdriver or similar tool, pry off the corner (1), disconnect and remove the cover of the door release handle (2).
Front door
Backdoor (station wagon)
Backdoor (sedan/hatchback)
3. Using tool BO-347, disconnect the door handle cover in the area (1).
Front door
Backdoor (station wagon)
Backdoor (station wagon)
4. Remove the door handle cover (2).
5. Remove three fasteners (1) door linings.
Front door
Backdoor (station wagon)
Backdoor (sedan/hatchback)
Note. To facilitate removal, fully lower the door glass. Mark the number and location of the fasteners for the correct installation of the inner lining of the door in the future.
6. Using the tool VO-569-A, disconnect the clamps (1) inner lining of the door starting from the bottom.
Front door
Backdoor (station wagon)
Backdoor (sedan/hatchback)
7. Disconnect the door lock cable.
8. Disconnect the electrical connectors and remove the inner lining of the door (2).
Installation
Note. Use new fasteners to install the inner door trim.
1. Install the inner door trim using new clips.
2. Connect electrical connectors.
3. Connect the door release cable.
4. Install three latches (1) door linings.
Front door
Backdoor (station wagon)
Backdoor (sedan/hatchback)
5. Install the door handle cover (1) and door handle cover (2).
Front door
Backdoor (station wagon)
Backdoor (sedan/hatchback)
6. Front doors: install trim for outside rear view mirror mounting.
Visitor comments