Removing
Remove the rear view mirror frame.
Remove the front door power window slot bar from the inside.
Remove the inner handle frame.
Remove the power window control.
Note. For a manual power window, use KM-317-B to remove a power window handle.
Remove and take out an internal covering of a forward door.
Note. Use KM-569-A to extrude mounting plugs.
Loosen 6 fixing screws (arrows).
Release 3 clips.
Installation
Establish an internal covering of a forward door.
Note. The service department always supplies the inner lining of the front door for vehicles with side airbags. If the vehicle does not have a side airbag, remove the foam piece at the top.
Position and clip the front door inner trim. Fasten 3 clips.
Tighten the 6 fastening screws (arrows).
Install the power window control.
Mount the inner handle frame.
Install the power window slot bracket inside.
Install the rear view mirror frame.
Visitor comments