Car automatic transmission Opel Insignia A

General information
Automatic transmission AF40-6 (1) six-speed electronically controlled with a mode shift lock system. The gearbox is installed directly behind the engine and...

Checking the level and condition of transmission oil
Note: The following operation includes two procedures: Filling with transmission oil with the engine off after performing repair work on the gearbox, removing...

Checking the pressure in the main lines
Examination Caution: Keep the brake pedal depressed at all times while performing the check to prevent unexpected vehicle movement, which may result in...

Checking for transmission oil leaks
Basic method 1. If you suspect transmission oil leaks, thoroughly clean the suspected leak area. 2. Drive the vehicle for approximately 24 km or until the...

Transmission oil change
1. Raise and secure the vehicle. 2. Remove the insulating covering from the engine compartment. 3. Unscrew the drain plug (1) and drain the transmission oil...

Replacing the valve body
Removal 1. Raise and secure the vehicle. 2. Remove the insulating covering from the engine compartment. 3. Remove the radiator. 4. Remove the automatic...

Replacing the gearshift lever on the gearbox
1. Apply the parking brake and place wheel chocks under the wheels. 2. Remove the battery tray. 3. Disconnect the selector lever cable port (1) from the shift...

Adjusting the selector lever cable
Removal Note: The selector lever cable adjustment must be performed only when the gearbox and selector are in the "Park" position. Failure to do so does not...

Specification

Special tools and accessories

Operating materials

Tightening torques for threaded connections
Note*: Replace the bolt/nut with a new one.

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: