Examination
Attention. Keep the brake pedal depressed at all times while performing the test to prevent unexpected vehicle movement that could result in personal injury.
Note. Due to the risk of overheating, a full load test should not take more than five seconds. You need to take a break to cool down. The oil level in the gearbox must be correct.
1. Check the oil level in the automatic transmission.
2. Raise and secure the car.
3. Remove the insulating layer of the engine compartment.
4. Remove the battery tray.
5. Remove the top crankcase plug (1).
Attention. The cooling fan may start to move even when the engine is turned off, which may cause injury. Keep hands, clothing and tools away from the area of operation of the radiator electric fan.
6. Install the DT-6329 adapter into the crankcase opening.
7. Install the EN-498-B hardware on the adapter.
8. Install the battery tray.
9. Connect scan tool and check oil temperature.
Note. The oil temperature should be between 50°C and 80°C.
10. Check the oil pressure with the selector lever in position «D»:
- Start the engine.
- Move selector lever to position «D».
- Check the oil pressure at idle and at full load - air conditioning and headlights on.
Note.
- Desired idle pressure (brake pedal not pressed): 370-410 kPa.
- Desired pressure value at full load: 1350-1460 kPa.
- After checking, turn off the engine.
11. Remove the battery tray.
12. Remove the EN-498-B hardware from the adapter.
13. Remove adapter DT-6329 from crankcase opening.
14. Install the top crankcase plug (1) with a new O-ring and tighten to 10 Nm.
15. Raise the car.
16. Remove the mounting bolt and remove the transmission control unit wiring harness bracket from the transmission.
17. Remove the bottom crankcase plug (1).
18. Install the DT-6329 adapter into the crankcase opening.
19. Install the EN-498-B hardware on the adapter.
20. Lower the car.
21. Install the battery tray.
22. Connect a scan tool and check the transmission oil temperature.
Note. The oil temperature should be between 50°C and 80°C.
23. Check the oil pressure with the selector lever in position «R»:
- Start the engine.
- Move selector lever to position «R».
- Check the oil pressure at idle and at full load - air conditioning and headlights on.
Note.
- Desired idle pressure (brake pedal not pressed): 570-660 kPa.
- Desired pressure value at full load: 190-213 kPa.
- After checking, turn off the engine.
11. Raise the car.
12. Remove the EN-498-B hardware from the adapter.
13. Remove adapter DT-6329 from crankcase opening.
14. Install the lower crankcase plug (1) with a new O-ring and tighten to 10 Nm.
15. Lower the car.
16. Remove the scanning tool.
Visitor comments