Removing
1. Remove the inner lining of the door with foil.
2. Remove the rear window trim.
Removing the rear door glass trim
3. Fully open the window.
4. Remove the sealing rubber from the window guide.
5. Turn out bolts of fastening of a back directing and pull out it upwards from mine of a window.
Bolts of fastening of a back guide
6. Tilt the door window forward and pull out with the guide from the cable window slider (refer to fragment A).
Glass removal
7. Tilt the glass forward and remove it from the door (refer to fragment B). Detail C of the illustration shows the position of the rear seal.
Installation
1. Tilt the window forward and install its door.
2. Insert the guide into the power window slider.
3. Install the glass guide and secure it with bolts. Press the rubber seal against the guide.
4. Open and close the window. The glass must move freely and evenly in the guides.
5. Stick the film. Seal or replace the torn film so that there is no draft in the cabin.
6. Establish facing of a door.
Visitor comments