Removal and installation the door lock (Opel Corsa B)

Removal

1. Remove the door trim.

2. Remove the protective film. Make sure that the film does not tear. Seal or replace torn film.

3. Remove the rear glass guide mounting bolts and detach the rubber seal.

Glass guide mounting screws



4. Pull the guide down.

5. Remove the outer handle rod (1), door lock (2) and inner handle (3) from the lock cylinder and door handle. To do this, turn the plastic clamp and disconnect it from the rod. Remove the rod from the clamp hole.

Outside handle rod (1), door lock (2) and inside handle (3)



6. Disconnect the central locking connector.

7. Loosen the mounting screws and remove the lock from the door using a Torx T40 key.

Lock mounting bolts



8. Remove the lock from the door.

9. If necessary, remove the central locking motor.

10. Installation is carried out in reverse order.