Corsa models
1. Unscrew the tailgate lift cord holders (arrows) from the interior lining.
Lift cord holders
2. Remove an internal upholstery from clamps.
3. Disconnect the lock drive rod (1) from the lock cylinder To do this, turn the plastic clip and remove it from the rod. Remove the rod from the clamp hole.
Lock drive bar (1) and lock fastener (arrows)
4. Use the Torx T30 key to fasten the lock to the rear wall of the door.
5. Installation is carried out in the reverse order.
Tiger models
1. Remove the cover on the lock holder.
2. Disconnect the lock bar from the cylinder. To do this, turn the plastic clip and remove it from the bar.
3. Turn out two bolts of fastening of the lock (5). Details 6 h 8 - lock cylinder drive.
Tigra Tailgate Lock Cylinder Actuator
4. Insert the lock and connect with the rod. Tighten the fastening bolts 20 Nm.
5. Set up the wedge (1) in the lid (9). To do this, remove the screws (4) and remove the plate (3). Vertical adjustment is made using plates (2), having a thickness 1 and 2 mm respectively.
6. Fasten the wedge lightly so that it can move. Open and close the tailgate several times. In this case, the wedge is installed in the longitudinal and transverse directions. Open the door and tighten the screws (4) with effort 20 Nm.
Visitor comments