1. Remove the rear door trim (see Removal and installation the rear door trim).
2. Use a screwdriver to pry up the wire harness holder…
3. …and remove the holder from the hole in the inner door panel.
4. Peel off the moisture-proof film from the inner door panel.
5. Remove the two screws securing the door trim support bracket…
6. …and remove the bracket.
7. Connect the power window control switch to the door power window control harness connector (see Removal and installation the rear door trim).
8. Install the front door glass in a position where the glass fastening latch to the slider is located opposite the service window in the door panel.
9. Pry up the edge of the outer window sill trim…
10. …lift it up, overcoming the elastic resistance of the holders, move it back a little…
11. …and remove the cover.
12. Use a screwdriver to pry up the edge of the plug of the technological hole in the rear end of the door…
13. …and remove the plug from the hole. Under the plug is the bolt for the lower mounting of the rear glass guide...
14. ...which must be unscrewed to ensure freedom of movement of the guide when removing the glass.
15. In the front part of the door, from its inside, use a screwdriver to pry up the piston of the front fastening of the seal…
16. …remove the piston…
17. …and remove the seal from the front edge of the door frame.
18. On the outside of the door, in its front part, use a screwdriver to pry up the edge of the glass groove…
19. …and remove the groove from the guide groove.
20. Remove the three screws securing the front guide.
The front glass guide also functions as a decorative door trim.
This is how the screws for securing the front glass guide are located.
21. Remove the door seal from its upper front corner…
22. …slide the guide up…
23. …and take it off.
24. Use a screwdriver to loosen the two tabs of the part A the glass fastening clamp to the slider and holding the glass (it's better if an assistant does this), remove it from the hole in the part B. Then remove the part B a retainer made of glass holes and a slider..
25. …raise the glass up…
26. …and, turning it in the opening as shown in the photo, remove it.
This is how the hole in the glass is located for attaching it to the slider.
The glass has its markings. When replacing, purchase glass with the specified markings.
27. Install the rear door glass and all removed parts in the reverse order of removal.
Visitor comments