2. Note the position and purpose of the wires located at the rear of the generator and disconnect the plug or connector, or terminals, depending on what is installed (see photo 8.2).
Photo 8.2 Generator electrical connections
3. Loosen and remove the generator adjusting lever bolt, mark the position of the ground wire. Loosen the lower support bolt and rotate the generator towards the engine. Remove the belt from the alternator pulley (see photo 8.3 A and B).
Photo 8.3A Generator adjusting lever and ground wire
Photo 8.3B Generator support mount and adjusting lever bolt
4. Remove the lower support bolt, and then disconnect the generator from the engine. Be careful not to drop or hit the generator as this could cause irreparable damage (see photo 8.4).
Photo 8.4 Generator/engine mounting bracket
Material published on the website: OpelBook.ru
5. Installation is carried out by performing the above steps in reverse order. Adjust the alternator drive belt tension as described in Chapter 2.
Visitor comments