Ignition Switch — Removal and Installation (Opel Ascona C)

1. Disconnect the battery.

2. Loosen the screws and remove the lower cover from the upper end of the steering column.

3. Remove the 2 small screws and pull out the ignition switch located on the side of the ignition switch housing (see photos).

Photo 12.ZA. Removing the screws securing the ignition switch.

Photo 12.3B. Removing the ignition switch from the ignition switch.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Kornev Georgy

Share information:

Opel Ascona C: Contact ignition system

TDC position sensor
Ignition coil — common part
Spark plugs and high tension wires — common part
Ignition timing angle — adjustment
Distributor — disassembly, inspection and assembly
Distributor — removal and installation

Ignition Switch — Removal and Installation (Opel Ascona C)

Visitor comments