2. Pull the horn button out of the center of the steering wheel and disconnect the wires.
Photo 8.2 Signal button removed
3. Set the steering wheel to "straight ahead" and unscrew the retaining nut.
4. Using a small extractor with two legs facing outwards, insert it through the two holes in the wheel hub and remove the steering wheel from the column shaft. Do not try to remove the wheel by force, otherwise the safety type steering column may be damaged (photo).
Photo 8.4 Removing the steering wheel
5. If necessary, you can replace the horn contact ring by disconnecting it from the wheel hub. When installing a new ring, make sure that the interrupting segment of the direction indicator switch is on the left.
6. Assembly is carried out in reverse order.
7. Make sure the steering wheel is properly aligned before tightening the steering wheel retaining nut to the specified torque.
Visitor comments